Drinking water / Automatic samplers

Refrigerated portable sampler model Avalanche

More information

Description

Specifications

Parameters

Accessories

Refrigerated Portable Automatic Sampler.
Housing made of double-walled ABS plastic with high resistance to weathering and corrosive environments.
Temperature control and recording.
Resistant to both high and low temperatures, with an operating range from 0ºC to 50ºC.
Quick and easy programming through intuitive guided menus in English.
Operation by means of peristaltic pump, performing sample collection at the speed recommended by the EPA (0.6 m/s), even at suction heights of 8 meters.

As of January 2022, it has been replaced by the new model BLZZRD

Autosampler:

Dimensions (HxWxD): 78 x 36 x 60 cm

Weight: 35 Kg

Possible bottle configuration:

14 1-liter polypropylene bottles

12 bottles of 350ml glass

4 bottles of 2.5 liters of polyethylene / 4 bottles of 2 liters of glass

1 bottle of 10 liters of polyethylene / 1 bottle of 10 liters of glass

Pump:

Sampling principle: peristaltic pump.

Suction line:

Length: 1 to 30 meters.

Material: Vinyl (or other materials for special applications)

Internal diameter: 9 mm

Maximum suction lift: 8.5 – 9 meters (26 – 30 ft)

Repeatability: ± 5 ml.

Automatic liquid detector by pressure at the pump inlet. Automatically compensates for different suction heights.

Controller:

Dimensions (HxWxD): 26 x 31.7 x 25.4 cm

Weight: 5,9Kg

Operating temperature: 0 ºC to 50 ºC

Housing made of double wall LLDPE with high resistance to corrosion and weathering, NEMA 4X, 6, IP 67.

Power supply: 240 VAC, 50 Hz.

– Sampling frequency:

From 1 minute to 99 hours 59 minutes, in 1-minute increments.

It allows sampling at non-uniform time intervals.

Sampling proportional to the flow rate, by pulses, from 1 to 9999 pulses.

– Sampling modes: Uniform time, non-uniform time, proportional to flow rate, event-driven.
– Programmable sample volumes: 10 to 9,990 ml in 1 ml increments.

– Rinse cycles: allow one to three rinses of the suction line before sampling to avoid cross-contamination.
– Retries: If it detects sample, 0 to 3 user selectable retries can be made.

Communication interfaces:

RS-232 and SDI-12 allows Plug&Play connection of multiparameter water quality probes of any brand without the need for additional interfaces.

Data transfer to PC through Flowlink software, also the “Storm Program” (optional) allows, connected to an ISCO flowmeter, to take samples activated by weather, level and rainfall.

Connection to flow measurement modules: Any ISCO flow measurement module:

710 ultrasonic flow measurement module

720 flow measurement module by pressure probe

730 flow measurement module for bubbler probe

750 flow measurement module by area/velocity probe

They are plugged directly into the socket and are automatically identified. The module management software is included in the sampler’s RAM memory.

Water sampling

Modules for flow measurement

Rain gauge

Multiparameter probes for measuring: pH, Conductivity, Temperature, Dissolved Oxygen, Turbidity, Chlorophyll, etc.

Bidirectional GSM modem.

Flowlink Software