Non-contact speed sensor model LaserFlow (MCERTS)

– The new ISCO LaserFlow area-velocity flow measurement sensor measures flow in open channels with non-contact technology. To measure the level it uses an ultrasonic sensor and to measure the velocity it uses a Doppler Laser sensor that can perform up to 15 velocity measurements to calculate the flow rate. Suitable for flow measurement in sewers, wastewater and open channels.
– The LaserFlow uses a laser beam to measure velocities below the water surface at single or multiple points.
– The Isco Laser-Flow flowmeter is the only flowmeter on the market that is MCerts certified with Class 2 certification, without any limitations.

Characteristics:

• Non-contact level and speed measurement
• Measurement of the velocity of one or more points below the surface of the liquid.
• Rugged and submersible housing, meets IP68 environmental requirements.
• No deadband for level or speed measurement
• Highly accurate flow rate readings
• Bidirectional speed measurement

Laser Flow Sensor:
Dimensions (H x W x D): 38.01 x 26.21 x 56.7 cm
Weight: 8.7 kg
Cable length: 10 or 23 m (other lengths on request)
Temperature range: -40 to 60 °C
Certifications: CE EN61326; FDA CDRH; 21CFR1040; IEC 60825-1
Flow accuracy: ± 4% of reading
Communication protocol: TIENet
submersible housing meeting IP68 specifications.
Submersible quick connect connectors.
Modular system capable of connecting up to 4 flow sensors or other parameter measurement sensors in the same unit. Modbus data output
Power supply: Possibility of use with alkaline batteries or 220 V mains connection.

Velocity:
Technology: non-contact, Subsurface Laser Doppler Velocity
Measurement range: -4.6 m/s to 4.6 m/s
Maximum distance from the liquid surface to the bottom of the sensor: 3 m
Minimum depth: 0.01 m (in normal flow conditions)
Bi-directional measurement selectable
Accuracy: ± 0.5% of reading (± 0.03 m/s)
Minimum velocity: 0.15 m/s

Level:
Technology: non-contact ultrasound
Measurement range: 0 to 3m
Accuracy (at 22ºC): 0.02 ft (±0.006 m) at <1 ft level change 0.04 ft (±0.012 m) at <1 ft level change Beam angle: 10 ° (5 ° from centerline) Ultrasonic signal: 50 kHz

Measurement of flow, level and velocity in raw, waste and treated water.