Farma

Integra E+ water purifier

More information

Description

Specifications

Parameters

Accessories

Continuous supply of purified water on demand for endoscope reprocessors, washer-disinfectors and other decontamination applications.

It uses proven reverse osmosis technology along with dechlorination and particulate filtration as part of the first stage of the purification process. Purified water from this first stage is stored in an integral stainless steel tank before circulating through a main ring. To maintain microbiological control of the system, the circulating water is continuously purified by passing it through a 0.2 micron filter and then irradiated with ultraviolet light at a germicidal wavelength of 254 nm.

Features

Completely self-contained in a rugged housing that is easy to clean, maintain and transport
Minimal installation and start-up
Integral 250-liter stainless steel storage tank, fully drainable
Integral raw water break tank with backflow protection
BMS alarm output connection
Panel-mounted backlit LCD display
Data logging of critical parameters
Automatic hot water sanitizing cycle.
Semi-automatic membrane cleaning cycle
Biological sample valve made of stainless steel, hygienic and disinfectable at the outlet
Automatic discharge of main ring available for temperature control
Incorporates leak detection system

Feed water requirements
Temperature (˚C)	1 – 35
Hardness (ppm as CaCO3)	< 4
Pressure (bar)	3 – 6
Consumption (l/hr)	1,000 max
Drainage flow rate (l/hr)	300
Recovery rate (%)	70
Pure water
Offset flow rate @ 10˚C (l/hr).	600
Purified water output	1,000 l/hr at 4 bar to 3,000 l/hr at 2.5 bar
Pure water storage	Up to 250 liters
Purified Water Quality
Conductivity	< 30µS/cm
Total viable count	< 10cfu/100ml
Endotoxin	< 0.25EU/ml
Silica	< 0.2 mg/l
Power requirements
Power (V/Hz)	400 / 50
Energy consumption1 (kWh)	0.6 – 1.3
Dimensions
W x D x H (mm)	1,000 x 750 x1,800
Weight
Working (Kg)	622
Shipment2 (Kg)	372